Quiz-summary
0 of 8 questions completed
Questions:
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
Information
International Mechanical Code IMC Practice exam 6
You have already completed the quiz before. Hence you can not start it again.
Quiz is loading...
You must sign in or sign up to start the quiz.
You have to finish following quiz, to start this quiz:
Results
0 of 8 questions answered correctly
Your time:
Time has elapsed
You have reached 0 of 0 points, (0)
Average score |
|
Your score |
|
Categories
- Not categorized 0%
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- Answered
- Review
-
Question 1 of 8
1. Question
1 points______ is the Refrigerants removed from a system in any condition without necessarily testing or processing them:
Correct
Please Refer: IMC Code – Definitions
Incorrect
Please Refer: IMC Code – Definitions
-
Question 2 of 8
2. Question
1 pointsThe ventilation rate for repair garages for natural and hydrogen fueled vehicles shall be at least _____ cubic foot per minute per 12 cubic feet of room volume:
Correct
Please Refer: IMC Code 502.16.1
Incorrect
Please Refer: IMC Code 502.16.1
-
Question 3 of 8
3. Question
1 pointsMake up air duct insulation installed within _____ of a Type I commercial kitchen hood shall be noncombustible
Correct
Please Refer: IMC Code 506.3.1.2
Incorrect
Please Refer: IMC Code 506.3.1.2
-
Question 4 of 8
4. Question
1 pointsAir Intake openings shall be located a minimum of _____ from lot lines or buildings on the same lot:
Correct
Please Refer: IMC Code 401.4.1
Incorrect
Please Refer: IMC Code 401.4.1
-
Question 5 of 8
5. Question
1 pointsThe maximum air temperature within nonmetallic ducts shall not exceed ______ :
Correct
Please Refer: IMC Code 603.5
Incorrect
Please Refer: IMC Code 603.5
-
Question 6 of 8
6. Question
1 pointsFire dampers are not required at penetrations of shafts where the penetrations are in parking garage exhaust or supply shafts that are separated from other building shafts by not less than _____ hour fire-resistance-rated construction:
Correct
Please Refer: IMC Code 607.5.5 Exp 1.4
Incorrect
Please Refer: IMC Code 607.5.5 Exp 1.4
-
Question 7 of 8
7. Question
1 pointsThe mechanical draft system vent shall vertically terminate at least ______ below window or gravity air inlet for the building:
Correct
Please Refer: IMC Code 804.3.5.4
Incorrect
Please Refer: IMC Code 804.3.5.4
-
Question 8 of 8
8. Question
1 pointsThe minimum thickness of the vent connector shall be _____ gage for galvanized steel:
Correct
Please Refer: IMC Code 803.8
Incorrect
Please Refer: IMC Code 803.8