When sizing a cooling tower, the highest anticipated _____ should be used:

The Cooling Water Temperature leaving a tower increases as the Wet Bulb Temperature _____ :

Two basic parameters required for specifying the right duty pump are:

The size of cooling tower dictates the rate of heat transfer:

In Evaporative cooling tower system the make-up water source is used to replenish around ____ of water lost to evaporation and draft

In ______ cooling towers there is no direct contact between the water with air:

The total heat transferred between warm water coming in contact with cooler air in cooling tower is equal to which of the following:

In cooling towers, higher temperature ______ corrosion potential:

The size of the cooling tower varies _____ with the temperature range:

Generally ______ fans are used on induced draft cooling towers:

Which of the following factors affects the cooling tower performance:

In cross flow cooling towers, the air moves _____ through the fill across the downward fall of the water:

For a constant flow, when the heat load decreases the range ______ :

In cooling towers, each pound of water evaporated removes approximately about _____ of heat from the water that remains

Approximately about _____ of cooling in cooling tower is through the sensible cooling:

In cooling tower, as the selected approach is _____ tower size increases exponentially

Design wet bulb temperature for cooling tower is the Wet bulb temperature that does not exceed more than ______ of the total hours in a year:

Higher the difference between the Dry Bulb Temperature and Wet Bulb Temperature, _____ is the relative humidity:

Difference between the cold water temperature at tower outlet and the entering air with wet bulb temperature is defined as:

The cooling tower design is governed by a relation known as the Merkel Equation: