The ______ bearing is used where the load is light and the noise must be low

In a three phase system, each phase is separated by:

Which of the following insulation class has highest permissible temperature withstand value:

Locked Rotor Current of compressor motors is of the order:

When more starting torque is needed, a start _____ is added to the motor:

Which of the following are motor starting and stopping devices: (Multiple Answer Question)

The service factor is the reserve capacity of the motor

As the load or torque on a motor increases, the amperage draw required to power the motor will ______:

The _____ is the current drawn by the motor just as it begins to start but before the rotor begins to rotate

Variable-speed motors operate at _____ efficiencies with varying loads

Slip is due to the load imposed on the motor while operating

A rule-of-thumb often used by service technicians is that the LRA is normally ______ the rated-load amperage

The heavy dashed lines on the installation diagram represents the line voltage ____ wiring:

_____ device protects the compressor during low outdoor ambient temperature:

The contacts of the start relay are connected in ____ with the _____ wiring: